The Tapering Jig is a sled with a table saw to create rip cuts on an angle. This item enables users to consistently adjust the reductions and cut to any hook up to 15 degrees.
Additionally, it is a useful and easy-to-build tool. So if you want to know how to make a Tapering Jig in an hour, carry on reading this article as we will show you the necessary steps.
How To Make A Tapering Jig In An Hour – 7 Easy Steps
Step 1: Cut out 2 Pieces of Wood
The first thing you have to do before cutting is to measure two pieces of wood. The length of the wood is usually 30 inches, and the width is about 3 inches.
You can freely adjust the two pieces’ size, yet those two have to be the same length. After finishing the measurements, you cut it with a Portable Table Saw and begin working on these wood pieces.
You can use a table saw or a hybrid one. If you are interested in the hybrid table saw, you can consult https://www.discoveriesla.com/best-hybrid-table-saws to find a product that suits you best.
Step 2: Connect the two pieces with a hinge.
Put one piece onto another and use a hinge to join them together. The hinge should be attached at one end of the jig. It also has to be at the center and parallel with the boards.
Step 3: Drill holes
On the opposite end, you drill a hole on each piece’s top side, like the image below. The holes have to be deep and be an inch up high on each board. Plus, they should be big enough for the 1/4-inch diameter bolts to go through snugly.
Step 4: Insert the bolts.
You put the bolts into the holes and use a hammer to tap them until they are firm in place.
Step 5: Build the Spreader Bracket
To build the Spreader Bracket, you cut out a wood piece with 8-inches length and 2-inch width. Then, you round the edges and draw a middle line at 1 inch away from each side.
Next, you drill three 1/4-inch diameter holes: two holes of 1/2 inch at each edge on the centerline, and the third hole at 1 inch in from one edge on the centerline.
After that, you use a jigsaw and cut along the middle line to create a slot in the spreader bracket. However, you have to leave a hole on the right side for the bolt.
Step 6: Attach a Lip
After cutting a 2-inch wide piece of wood, you join this piece to the left side of the jig with some deck screws. It should be 1 inch away from the top of the board.
Step 7: Attach the Bracket to the board
To finish this Tapering Jig, you attach the bracket to the board.
Place the hole on the right bolt and the slot over the left bolt. Tap it down into its place. After you add a flat washer, you lock the bolt onto the right bolt. Then, you tighten till it is snug, yet not too tight to rotate on the bolt.
We hope this article about “how to make a Tapering Jig in an hour” will help you successfully create one for yourself. These steps are very easy to follow, so you don’t have to worry too much. Anyway, good luck with your work, and thank you for reading!